If you're like most fishermen, there's 2 things you really hate More holes in your boat and the inability to reposition your rods as fishing conditions dictate simply because you don't have enough rod holders. This ingenious suction mounted rod holder eliminates both concerns. To mount it, all you need is a flat, non-porous surface and about 4 seconds. Simply place the suction pad against the surface, press several times on the integrated finger pump and - VOILA! - you have a newly installed rod holder on your boat, car's rear windshield or home wall. Oh don't like it there? No problem, move and reseat as many times as you need. Perfect for mounting to your bait tank while rigging lines or up in the gunwhale of your boat where there are no built-in rod holders!
I'm worried it will fall off That's the most common concern with these, but there's no need to fear. Ever seen a couple workers carrying a 10-foot sheet of skyscraper glass? Yup, they're using the same suction technology employed in these fishing contraptions. After mounting the rack it's best to pull once or twice to confirm it was properly seated. Otherwise, you're good to go, as these racks are rated to a pull strength of 210 lbs. And remember, you're only carrying 3 fishing poles. For even more peace of mind, the pump tab has an orange indicator that visually shows suction power is being lost.
For use on boats, cars, walls, etc. If it's beginning to seem like you need multiple racks for every rod you own, now might be the time to consider the Suction Mount Rod Rack. Slap it on the center console of your boat, then when you return to the dock it's just a few seconds to unmount and place on the rear windshield of your truck (just watch out for driver-thru's!). Or use it on the wall at home. Any non-porous, flat surface will allow you to use this rack.
Pro series - removable pins Each rod holder includes a removable pin at the base of the tube. This allows you to fit long-butt spinning reels when you need the extra length. Put the pin back in for conventional gimballed rods with standard length handles.
Constructed of stainless steel hardware and UV resistant HDPE Means suction pad, mounting track and all 3 rod holders will hold up to the salt, spray and sun of whichever marine environment you frequent.
Works great. Can move it all over the boat with out drilling holes. Sticks long and hard.
(Including Alaska and Hawaii)
Great News - We have a dedicated International Store just for you!
It looks like you are visiting from outside the continental United States. If you would like to shop and ship any products outside the continental United States you must order from our International Store. It is optimized specifically for our customers outside of the continental United States.